Collect flotsam at the right tide
In Savebot: The Last Garden, use Thalassa’s tide sensor to choose when a robot should visit the foreshore. Flotsam is available at the right point in the tidal cycle. Observe an actual deposit and use the live tide reading to set the condition.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Watch the foreshore with the tide sensor visible for a selected robot. Note a reading when flotsam becomes accessible. Use the current world’s display rather than importing a number from another program.
- Teach the robot to take the collection action during that state. Give it a repeat or condition appropriate to your mode so it can check again when the tide changes.
- Watch two visits. Confirm it reaches flotsam when available and avoids wasting its collection trip in the wrong state.
How to tell it worked
The robot collects from the foreshore in the observed tide state and its program responds as the cycle changes.
If you are still stuck
If the robot heads out but finds nothing, check tide, flotsam location and the selected robot’s live condition at the moment it commits to the trip.
Establish a usable sample at one piece of shoreline
Choose one beach segment you can identify from inland. Watch for a visible piece of flotsam and select the robot you intend to send there. Read its tide value while the program is running. Note both the visible condition of the shore and the reading that goes with it. Watch the actual pickup. This gives you a shoreline sample where material is available and collectable, instead of a guessed sensor value.
Next observe the same stretch when conditions differ. If water covers the route or the flotsam is absent, write down what changed. The developer says there is a right point in the cycle. The published description does not provide a numeric value that guarantees a pickup at every location. Take the useful transition from the area you can test.
Decide whether the departure or arrival is mistimed
Watch one trip from the moment the tide condition selects it. Compare the state when the robot starts with the state when it reaches the item. A robot starting far inland can reach the beach after the pickup window even when its departure condition was reasonable. Try a nearer starting point or compare an earlier part of the usable window, while keeping the flotsam site constant.
If it reaches the shoreline while the material is still visible, follow the action until it either picks up the piece or fails. Check that the selected goal is the flotsam you observed. If the robot never departs, inspect the actual tide condition and whether an earlier branch prevents it from reaching that decision. These two failures involve different parts of the trip.
Verify the return leg and the next visit
After collecting a piece, watch the robot return to its planned inland work or deposit. Check where it is when the shore changes. A successful pickup can still leave the next trip starting from an unsuitable place. Base the next test on a complete cycle including the departure, pickup and return. Confirm the robot stays out of the temporary shore route when the tide is wrong for this job.
If moving the program to another beach, keep the first beach as a reference and run a fresh observation at the new one. The new trip can have different approach timing. For construction, use the spring-tide guide and check the flood boundary separately. A shoreline that supports a pickup at one stage of the tide can still flood above that point later in the cycle.