Move heat through a Twilight relay
In Savebot: The Last Garden, send a robot to gather heat on hot ground, then drop it off at a heat relay where another robot can take it. Watch one deposit and one withdrawal to verify the pipeline.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Choose a heat-gathering robot and identify the hot ground the world describes. Keep the first trip simple so you can check whether heat was actually gathered.
- Teach the robot to leave that heat at the chosen relay. Watch the relay and the chosen robot after the deposit rather than assuming arrival means transfer.
- Give another robot the corresponding pickup behavior. Run one cycle and check whether the relay can provide heat again after the next delivery.
How to tell it worked
The first robot delivers heat and the other takes it from the relay without direct player intervention.
If you are still stuck
If no heat arrives, isolate the gathering step. If it arrives and disappears before the intended robot gets there, inspect the timing and current relay state. The developer description gives no numeric heat threshold.
Trace one heat handoff from the ground to a recipient
Use a hot patch the producer can reach and a single relay you can recognize. Observe the gathering action on that patch and check the robot's state as it leaves. Follow the trip to the relay and look for the deposit. If the producer leaves the ground without heat, find out whether the gathering instruction ran with the intended target. If it carries heat to the relay but there is no visible handoff, inspect the drop-off step using the same source.
Use the second robot only after you can see one successful deposit. Its program needs to take heat from the same relay. Bring it through the planned route and observe the action. Confirm that it ended up with the heat. Seeing the producer leave the relay only establishes the first half of the job. The withdrawal is the evidence that the second half works.
Compare an empty arrival with an unsuccessful withdrawal
If the receiving robot arrives before a deposit, record that sequence. Test once after the relay already has heat. A successful second case means you should examine when ordinary work brings the robots to the relay. If heat is already available and the receiver still takes none, check that it runs the withdrawal action and has chosen the same structure as the producer. Keep other robots from obscuring the observation while you trace the pair.
If the heat was there earlier and is gone before your intended robot arrives, watch the relay through that interval. If another robot took it, you have an observable competing user. If you see no withdrawal, compare the visible states and what happened at the relay during that period. The source establishes how a relay transfers heat and does not give a universal amount or hold time.
Observe one repeat after interrupting ordinary work
After a transfer works, follow a fresh gathering trip and a second pickup. This exposes a program that relied on a relay being stocked only at the start. If a solar flare interrupts either robot, observe when ordinary work resumes and check a complete new transfer. The recipient that returns first can arrive at an empty relay while the producer is still on its way. Use the direction of the observed failure, gathering, deposit or pickup, to choose the next change.
When adding another relay, keep the working pair and check each route by its endpoints. Compare the assumed target with the actual structure the robot reaches. Extend the heat route once each side has completed the handoff you intended.