Sylve

Clear grey fungus, extend the root network and teach other robots how to answer a help call.

Choose between a clear patch and a boundary that encloses it

Use mowing when the immediate goal is fertile soil under part of the grey fungus. Begin with a small patch at a visible edge. Point the robot at that patch, watch the mowing action and inspect the ground it leaves behind. If the target still looks grey after the robot passed, watch whether the mowing action ran at that position and whether the ground you inspected was actually the target. Keep one adjacent area available for comparison.

For grafting, locate an existing root network and inspect its edge against the grey area. Attach the new growth at that edge. The intended outcome from the developer's explanation is the retreat of grey that is surrounded by the network. Check the entire boundary, including the side away from the robot. A visible graft at one point confirms attachment and is only one part of enclosing a patch. Consider how the next attachment would close an opening before choosing it.

Give the help call its own first test

Set up one sender and one responder you can identify. The official Sylve description says robots hear the call for 30 seconds and need a taught program to answer. Make sure the responder is easy to watch during the first call. Note the event that makes the sender call and the action that should count as a reply. Seeing the sender finish its own job gives little information about whether a second robot answered.

If nobody comes, check when you sent the signal, which robot should respond and whether its program reached the response decision during the window. If it does respond but reaches an unexpected area, preserve the timing and inspect the action it took. If the action begins and still fails to clear fungus or extend growth, look at the assigned world task separately from communication. A robot can hear the call and still need the right instructions for the job itself.

Use one observation to choose the next change

A bare or fertile patch after mowing, a shrinking grey area inside a complete root boundary and a visible responder action are distinct results. Choose the relevant one while you test. If the mower works in isolation but a larger program stalls, inspect where it leaves and rejoins the job. If a graft takes but the fungus remains, find the next visible gap before duplicating the graft. If the responder misses the call, start with a convenient test that reproduces the 30-second window. Combine these jobs only once you know which robot and target are responsible for each result.

Check what actually cleared before expanding

When two jobs are active near each other, visit the patch before each trial and keep the fungus edge visible while the robot acts. If an area was cut by the mower, compare that individual clearing with any grey retreat inside the root boundary. Assign the next robot to a separate patch for its first test. You can then tell whether the new assignment contributes to the clearing or simply runs through ground the first robot prepared.