Sow seeds toward another island

In Savebot: The Last Garden, use the Thalassa-specific sowing block for seeds that travel on the wind. The developer describes sowing toward a distant island as a distinct operation from releasing coral larvae into ocean current.

Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .

Steps

  1. Choose a robot and identify the wind-sowing block available in its Workshop on Thalassa. Keep the test focused on one sowing action.
  2. Observe where it sows and which island receives the result. Use any relevant world conditions provided by the game and inspect the actual outcome before making the action repeat.
  3. If the test reaches the intended area, add the repeat or condition that makes sense for your current planting goal. Watch a later attempt to see whether the same route remains useful.

How to tell it worked

A seed reaches the intended distant land area using the wind-sowing operation.

If you are still stuck

If seeds do not reach the intended island, inspect the action and current conditions in the Workshop. The source does not specify exact wind thresholds or guarantees for individual islands.

Set up a trial with a visible source and destination

Select one robot and locate the Thalassa sowing action for windborne seeds. Pick the island you want to reach before running the job. Choose landmarks on the sending shore and the intended receiving area that you can find again. The official world description distinguishes sowing toward a distant island from releasing coral larvae into water. Confirm that the action shown in the Workshop is the land plant action you intended.

Start with a single sowing you can follow. Observe where the robot acts, the direction or result the world makes visible and what happens in the receiving area. If you cannot see the release and the outcome together, note exactly where the robot was when the action ran. Then inspect the destination and any nearby likely landing area. A completed sowing command gives you a confirmed starting event even if you never see seeds on the target.

Diagnose a miss using one recorded launch

If the action never runs, watch the selected robot's controlling decision and check its starting location. If it runs and you observe seeds going elsewhere, compare the launch point and observed conditions to the direction you wanted. Try a change to one input, such as the starting location or the moment of sowing. Keep the destination constant so you can judge whether the new observation is closer to the intended island.

When seeds visibly reach the intended area and the expected plant result is absent, investigate the receiving patch and any requirements the current game shows for the plant. Keep the observation of arrival separate from establishment. The announcement confirms the wind action without a numerical wind rule or a guarantee for each island. Record which parts of the trip you can verify instead of using the absence of a plant alone as proof that the wind was wrong.

Repeat a successful case before sending more

Use the same launch point and a similar visible situation to see whether you can reproduce the result. If you later target a different island, make it a new small trial. A successful westward or eastward result from one spot says only what happened in that trial. When you add the job to a larger routine, watch the first launch after the switch. Confirm the program still invokes the Thalassa sowing action under the conditions that worked for that destination.

If the wind produced a different result on repeat, compare the robot's launch position first, then the visible wind state or direction available for that run. Keep those observations beside the receiving patch result so you can compare them on a later attempt.

Related tasks

Sources