Release coral larvae into the current

In Savebot: The Last Garden, use the Thalassa coral-larvae block to release larvae into the water current. Test a single release and inspect where it goes. Use the wind-sowing block for land plants instead.

Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .

Steps

  1. Check that the robot has the world-specific larvae action in its Workshop. Read the block’s current inputs before telling it to repeat.
  2. Run one release and observe the water area you were trying to reach. Compare what happened against the chosen location and the current the game shows.
  3. Repeat only after you can see the intended action and outcome. If the conditions change, update the routine to account for the readings your build exposes.

How to tell it worked

The robot performs a coral-larvae release into the current serving the area you intended.

If you are still stuck

If you see the wrong planting action, check which world-specific block was used. The announcement establishes the larvae operation but does not publish survival or placement thresholds.

Prepare one release you can follow

Choose the place where you want to test the coral larvae action and a downstream area you can return to. On Thalassa, the developer describes larvae moving in the water current. In the Workshop, confirm that your robot uses the release action for larvae. The seed-sowing action belongs to the separate wind task. Test the release with one robot from a shoreline or water location the game lets it use.

Observe the robot's actual position when it reaches the release action. Note any direction or movement the game makes visible after it acts. If you cannot follow the whole route, keep a visual landmark for the release position and inspect the water and intended area afterward. The first comparison should tell you where the start was and whether you saw any part of the route, even if the final outcome is still unclear.

Tell an unexecuted release from a release that went elsewhere

If no release appears, open the selected robot's program and follow the decision that controls it. Confirm the target location and see whether the action actually runs. If the robot cannot reach the planned spot, make a smaller trial at a spot it can reach. This distinguishes an inaccessible start from a current that carries larvae away from the intended destination.

If you can see the action run and see larvae travel in a different direction, leave the action in place. For the next trial, vary the release position or use another moment while keeping the intended area fixed. Record what changed. If the path is not visible, use the world observations you actually have and avoid concluding that the larvae followed a specific route based on a blank destination alone.

Check the destination separately from the start

Look for the outcome at the target and around the area where the current took the larvae. A completed release is evidence that the action ran. The placement of later coral requires its own observation. The developer description does not give guaranteed landing points or numeric survival conditions. Use any planting or placement information your current game exposes in that location and keep it separate from your evidence about the release.

Repeat the most informative trial before building the release into a repeated routine. Keep the robot, launch point, intended area and observed movement together in your notes. If a second run differs, first compare where the release actually happened. This gives you a way to refine the route without making unsupported assumptions about every part of Thalassa's current.

Related tasks

Sources