Graft a root network around grey fungus
In Savebot: The Last Garden, graft new species onto the edge of a root network to enclose a grey patch. The Sylve announcement says the grey surrounded by the root network retreats.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Find an existing root edge near the patch. Trace where you can extend the edge around the grey instead of assuming one graft automatically surrounds it.
- Use the grafting action at the edge and watch the network change. Work on a small patch first so you can locate any gap in the resulting boundary.
- When the patch is surrounded, observe whether the grey inside retreats. Make the next graft where the boundary still needs coverage rather than repeating an already connected position.
How to tell it worked
The network encloses the selected grey patch and the grey inside the boundary retreats.
If you are still stuck
If one small graft does not change the patch, inspect the full root edge for openings. The announcement describes the effect of surrounding grey, without a required shape or radius.
Inspect the boundary before placing the next graft
Start with an existing root network beside some grey growth. Look at the network from the side facing the patch and follow its edge around the area. Identify the opening that still connects the grey inside with the surrounding grey, if one is visible. Pick a graft that can extend the existing edge toward closing that gap. Forgeur Games describes grey retreat when the network surrounds it, so that is the condition you are trying to produce.
Watch the robot place the graft and verify that the new growth is connected to the edge you chose. A successful placement can extend the network without fully enclosing the patch. Follow the updated boundary, including its far side. If the near opening is gone and the grey remains, look for another opening further around the edge before changing the entire layout.
Tell a placement failure from an enclosure still in progress
If the robot never grafts, check the selected action, species and target point in the game. Inspect whether the robot is working on the edge of the intended network. Keep the same grey patch while testing a nearer or clearer connection point. If the graft attaches where intended, preserve that observation and continue inspecting the shape. The later retreat depends on what area the growth surrounds.
If two sides appear to touch, inspect the area closely and follow the entire perimeter from a recognizable landmark. A view of only one connection can miss an opening on the opposite side. The source gives no required number of grafts or exact enclosure shape. Make each new attachment based on a visible gap or a position whose result you can check.
Compare the enclosed area with an open one
When the network appears to surround the patch, observe the grey inside. Leave a nearby open area available for comparison if possible. Record which part retreats after you complete the boundary. If you need fertile soil immediately in one spot, the separate mowing guide covers that direct action. Using both actions on the same patch during the first trial can make it hard to tell which job produced the change you saw.
Once a first enclosure works, copy the process to another patch by starting with its existing root edge. Inspect the new boundary independently because an opening is a feature of that layout. Keep one successful graft and the final enclosure state in view as you add more growth. A completed grafting task leaves a connected boundary and an observable retreat in the enclosed area.